Jump to content


Photo

Opening ID set to Mask


  • Please log in to reply
3 replies to this topic

#1 Yvon Gonthier

Yvon Gonthier

    Advanced Member

  • Members
  • PipPipPip
  • 1,288 posts
  • LocationOttawa

Posted 24 May 2017 - 01:40 PM

I opened an existing plan and most of my opening ID's didn't show up anymore. Scrolling the mouse over and I can see it's there. Searched for visibility settings but all good.

 

Found out that for some reason, all those openings are now set to mask. Opened another plan and most of the window ID's are visible but most doors to mask. This is going to be a pain to verify all existing drawings and not forget in the future. Anybody else experience this?

Attached Files



#2 Brent Hyndman

Brent Hyndman

    Advanced Member

  • Members
  • PipPipPip
  • 1,549 posts

Posted 24 May 2017 - 02:47 PM

Please create a ticket with one of the drawings and will look into it further.



#3 Yvon Gonthier

Yvon Gonthier

    Advanced Member

  • Members
  • PipPipPip
  • 1,288 posts
  • LocationOttawa

Posted 25 May 2017 - 09:05 AM

The problem finally is not that the Mask is being checked when going from 2016 to 2018 The problem is "The Mask setting for openings is incorrectly hiding the ID value".



#4 Brent Hyndman

Brent Hyndman

    Advanced Member

  • Members
  • PipPipPip
  • 1,549 posts

Posted 25 May 2017 - 12:08 PM

Thanks Yvon.

 

The issue with masking the ID has been reported on CO-47467.






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users