Has anyone noticed that when you try to add a reference point to an exterior wall that it wants to put the point on the material and not the bearing? It also happens when drawing a line or box. Is there a setting that I am missing?
3 replies to this topic
#2
Posted 01 August 2017 - 01:25 PM
As far as i remember, it's always been that way. There's no setting, but once placed, the point can easily be moved to where you want it
Personally I think it should snap to the same point on the wall that's defined as the TRACE WALL POSITION in the wall definition.
Keith
There are 10 types of people in this world ....... Those who understand binary, and those who don't.
Softplan user since version 5.5.2.5
www.homehardwarekingston.ca
There are 10 types of people in this world ....... Those who understand binary, and those who don't.
Softplan user since version 5.5.2.5
www.homehardwarekingston.ca
#4
Posted 01 August 2017 - 03:53 PM
Cant comment ... I've never turned exterior material off!
Keith
There are 10 types of people in this world ....... Those who understand binary, and those who don't.
Softplan user since version 5.5.2.5
www.homehardwarekingston.ca
There are 10 types of people in this world ....... Those who understand binary, and those who don't.
Softplan user since version 5.5.2.5
www.homehardwarekingston.ca
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users