1 reply to this topic

[Yvon Gonthier]

I've had issues with profiles in the past not reversing when reversing plans but that was dealt with (I think). Now rotating a plan seems to have the same issue.

 

I'm assembling individual towns to form a block but have to rotate the plans. All the profiles that I had drawn while in 3D for the original plans didn't rotate with the plans so are floating in space instead of being in their correct locations. Profiles for front porch nosings, brick patterns at garage door sides, flashings, window trims and gable double fascias are floating as saeen on the right or inside the units.

Attached Files

•  p.JPG   89.46KB   2 downloads

[Brent Hyndman]

Thanks Yvon. This has been reported. CO-48070. 

 

If you use the Neighborhood tool and edit the Position- Angle of the drawing there it holds the profile position as it should.