3 replies to this topic

[Richard VanEk]

Just started using 2018 today, found out I have no number display on my dimensions.  I have the dimension line and the slashes but the actual dimension number does't display.  Also when I type a note it just doesn't show up.  Also when I print everything print but the letter and numbers.

[Brent Hyndman]

Richard,

 

Best place to start would be to install the SoftPlan fonts again. See the bottom of this page: http://softplan.com/.../?page_id=2819 

 

If that doesn't resolve the issue, please contact support.

[Richard VanEk]

I have contacted support been advised to re install fonts and then reset to project.  Didn't  work.  Should I try it again

[Brent Hyndman]

Continue to work with support.