3 replies to this topic

[Tom Rogers]

Has anyone else had this problem? It doesn't happen on all plans but it does on more than I am comfortable with that I will make a change in a drawing, say in drawing mode, and when I go to flooring mode or another mode (in this case it is a custom one) that I get dimensions that decide to go off in another direction.  There is no way to clean it up.  End up having to erase and re-dimension.  It is hard to know when or where it might happen or the tasks that I do that may cause it so it is hard to duplicate. 

 

 

 

[Yvon Gonthier]

Can't say that I've seen lately. I think the times that I saw it in the past was when rotating a plan.

[Martin Livingston]

The only time I have ever had a problem with dimensions is when the extension was referencing a hidden object or an object on another layer that was turned off.

[Tom Rogers]

Good point Martin.  Not sure if that is the case in this one but that is a possibility as these were in my custom mode with different layering