2 replies to this topic

[Neil Paquette]

This is an issue I seem to be having every time I design a foundation for a metal building.   Where I have to design a pier for a column, the wall needs to be thicker to fit the rebar cage.  I usually use a 24" thick concrete wall in SP.   The intermediate piers clean up nicely.  However at the corners it is generating a line where the two different wall thicknesses meet end to end,.  The one I am showing in the picture is an example.  The pier / 24" wall at the corner is running up and down.   The wall join coming in from the left cleans up nicely.  I am getting the line at the end to end match. 

 

Thanks, 

 

Neil Paquette

 

 

Attached Files

•  Wall Issue.png   119.39KB   1 downloads

[Dennis Hilborn]

That may be one for "adjust wall materials" in the tools menu.  Since I don't have an example to play with it might not work out.

[Yvon Gonthier]

Wall joining is always touchy. Did you try to increase the wall join tolerance for the vertical wall since it's joining in a thicker wall?