2 replies to this topic

[David Bearss]

Somehow my floor assembly came in to low in relation to lower floor wall height. I cannot figure out how to adjust floor elevation to make the correction. This raises a future situation on how to adjust wall heights say for instance if somebody wants to upgrade from 8 foot walls to 9 foot walls.

 

Attached Thumbnails

• 

[Jim Johnson]

Look at your lower level in "Profile Mode".  It will tell you which walls are incorrect.  Looking at your image, it appears that the wall on the left is the incorrect height or the offset for that wall is incorrect.  It's hard to tell from just the image you posted.  Where is your reference circle?  There also appears to be a sill plate under the section of floor at the left wall and beyond.

 

Look into using "Set Wall Tops" in the edit menu also.

 

Changing from 8' walls to 9' walls should be simple.

[David Bearss]

Hi Jim,

Your simple comment about reference point was it. I had located it at a corner of the garage which was setting everything off. Also figured I don't need a sill plate at second floor floor system.