Jump to content


Photo

Elevation not Generating?


  • Please log in to reply
6 replies to this topic

#1 Brent Putney

Brent Putney

    Newbie

  • Members
  • Pip
  • 9 posts

Posted 18 September 2019 - 03:10 PM

I had 2 elevations on this project from a few days ago open and done enough for what i need. Now i went to do the last 2 and all i get is a line, same happens on the 2 i already have when i try doing them again

Any ideas?

 

Thanks

Attached File  Elevation Not Generating.png   185.68KB   0 downloads



#2 Mark Petri

Mark Petri

    Advanced Member

  • Members
  • PipPipPip
  • 1,497 posts
  • LocationEvergreen, CO

Posted 18 September 2019 - 03:38 PM

I assume these are basic questions, but why not be sure-

 

Are all the floors in the model stack?

 

Are all the walls set to extract in 3D?

 

Are the materials all checked to display?

 

Did you try switching render modes to see if something shows up?


Mark Petri

Petri Building and Design

 


#3 Brent Putney

Brent Putney

    Newbie

  • Members
  • Pip
  • 9 posts

Posted 18 September 2019 - 03:48 PM

yeah, my 3d is up and all is working there. i did a cross section no issue either, just the elevations. extract all checked also

Attached Files



#4 Mark Petri

Mark Petri

    Advanced Member

  • Members
  • PipPipPip
  • 1,497 posts
  • LocationEvergreen, CO

Posted 18 September 2019 - 04:59 PM

Interesting. I'd suggest turning off your computer and restarting. Maybe it's a program or system error??


Mark Petri

Petri Building and Design

 


#5 Dennis Hilborn

Dennis Hilborn

    Advanced Member

  • Members
  • PipPipPip
  • 816 posts
  • LocationDFW Texas

Posted 19 September 2019 - 07:19 AM

Viewpoint zoomed in too close?



#6 Brent Putney

Brent Putney

    Newbie

  • Members
  • Pip
  • 9 posts

Posted 19 September 2019 - 09:09 AM

tried zoom extent and it didn't change



#7 Paul James

Paul James

    Advanced Member

  • Members
  • PipPipPip
  • 251 posts

Posted 19 September 2019 - 03:38 PM

It might be a rogue roof soffit or fascia- extending off into infinity. Try turning those off and re-zoom to extents. If it is that, you'll notice it affects the model shadows, too.






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users