I have 2 walls that aren't meeting in 3D or elevation. I tried adjusting and fillet. It looks fine in plan view but I can't get them to appear correctly in 3D or elevation Attached is jpg
Corner not meeting
#2
Posted 30 August 2020 - 05:23 PM
Gary try reducing the wall join tolerances at the wall intersections.
There may be a wall, most likely the bump out section wall that is
interrupting the main house wall joining.
Tools>Reduce Wall Join Tolerance; Click on small circle top of each wall, cleanup
#5
Posted 31 August 2020 - 07:32 PM
The walls that are close like that do not really like to stay where they should. Even when clean up is unchecked and anchor, and on a locked layer SP sometimes decides it knows better and cleans the joining up again. SP - please give us control over the way walls and beams join and then the ability to lock them that way until we decide to change them.
- Keith Almond likes this
Mark Petri
Petri Building and Design
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users