6 replies to this topic

[Gary Wicklund]

Doing a covered deck with a parachord truss vault

 

I’ve added the roof , added the ceiling sloping from both sides

 

how do I get rid of the gable siding and the gable end of the ceiling?

 

looked through the forums But can’t find any references to exterior vaults 

 

thanks

[David Zawadzki]

Did you try unchecking gable wall supplied by roof.

I am not at my computer so bear with me...

[Keith Almond]

Edge edit the ceiling and change that edge to gable. If it has a solid end at the moment its a vertical hip.

[Gary Wicklund]

Did you try unchecking gable wall supplied by roof.

I am not at my computer so bear with me...

Yes, that worked ok, just clearing the ceiling gable was the issue

[Gary Wicklund]

Edge edit the ceiling and change that edge to gable. If it has a solid end at the moment its a vertical hip.

Thanks Keith, that was it. I wasn’t editing the edge.

[Keith Almond]

Personally, with a parallel chord roof, I normally add 2 ceilings in the same place ... One as thick as the parallel chord to give the exterior finish, and then a standard exterior soffit finish below that to show the ceiling finish.

[Gary Wicklund]

Personally, with a parallel chord roof, I normally add 2 ceilings in the same place ... One as thick as the parallel chord to give the exterior finish, and then a standard exterior soffit finish below that to show the ceiling finish.

I’ll give that a try

 

I used 2 walls top set to roof and raked bottoms to finish off the chord gable

 

I never thought I could change the ceiling thickness.  Lol