I am yet to figure out what exactly is happening but this is not the first time and I am not sure if anyone else has experienced this yet.
This has happened to me about half a dozen times that I have caught just in the SoftPlan 2022 Version. I had not seen this previously. The first couple that it happened to I probably started in SoftPlan 2020 and then opened them up after in 2022 so I thought that might be a cause but now with the latest drawing, I made this completely in 2022 so I know now that is no longer it.
I am attaching 2 screen shots.
The first is an Existing First Floor as built drawing that I created of an existing house that we are doing some renovating to. This shows on the front wall 2 window openings which are 3050 and one center door that is 3 feet wide.
2021-08-30.png 141.69KB 0 downloads
Then I Saved As to create my Proposed First Floor drawing and Repeat Edit to label all Openings as existing. Then went on to start drawing the proposed addition to the right side of the home.
Now I am getting ready to make some PDF files to send over to the client and I catch a glimpse of the front wall where the 2 windows and door have all joined together and been pushed far over to one side of the wall.
2021-08-30 (1).png 147.96KB 0 downloads
That pretty much describes a very similar scenario that I have seen about half a dozen times so far where opening join and move in the wall span.
I am not sure yet what might be causing this and will continue to monitor but I was curious if others have seen this around?