3 replies to this topic

[Nicholas Colantuono]

I am trying to draw a piece of dry wall and have it clip to my roof.

 

I have attic roof trusses in my model.

 

When I hit clip to roof,  it seems to just clip to where my attic truss ceiling is, not

to the underside of roof.

 

Any idea why?

 

Attached Thumbnails

• 

[Nicholas Colantuono]

Or I can try to adjuset the point of the wall?

 

How can I raise the middle to make the shape of a gable?

Attached Thumbnails

• 

[Mark Petri]

Extend the roof in that area, then try fit to roof. Or, use the tools to adjust the wall with rakes and set it to two sections and adjust accordingly.

[Keith Almond]

Not sure this is the case, but a wall on a higher floor plan will not fit to a roof that has been created on a lower floor. Just saying so that you know for future reference.