Relatively new to using Softplan....but I'm designing a kitchen and I changed the countertop finish in 3d from a granite to maple (trying to emulate a butcher block, and now you can see thru the countertop surface to see the knee wall below and the cabinets. Any tips on this? Please and thanks.
See thru Countertops
Started by
Mark Miller
, Mar 29 2016 08:20 AM
3 replies to this topic
#3
Keith Almond
-
- Members
-
- 5,098 posts
Advanced Member
- LocationBrockville, Ontario, Canada
Posted 29 March 2016 - 08:28 AM
Edit the surface in the 3D - SURFACE EDITOR - OPTIONS TAB and change the opacity to 100%
Keith
There are 10 types of people in this world ....... Those who understand binary, and those who don't.
Softplan user since version 5.5.2.5
www.homehardwarekingston.ca
There are 10 types of people in this world ....... Those who understand binary, and those who don't.
Softplan user since version 5.5.2.5
www.homehardwarekingston.ca
#4
Mark Miller
-
- Members
-
- 3 posts
Newbie
Posted 29 March 2016 - 08:39 AM
Opacity was at 100% but thanks. It was the Parallels/Mac side of it I think. The change I made just didn't come through. I shut it down and then reopened it and reselected a new top and it made the change. I need to get a separate PC to only run Softplan on I think. Thanks again.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
