2 replies to this topic

[Jay Preeshl]

Could anybody help me out on how to tie 8/12 gable into this 4/12 main roof, which is not very wide so ridge line is much higher.

This is an angle addition on to the end of existing house. I know how it should look but can't get it drawn.

Also if you notice the Sub Fascia runs into house by that gable. (Its a goofy area) Any ideas on that?

Angle of addition to house is 15 degrees.

 

 

Would appreciate anybody's help

 

Jay

"GO BADGERS"

Attached Thumbnails

• 
• 

[Keith Almond]

You can fix the sub fascia issue with a hole. Similarly the Rear of the 8:12 roof can be cut with a hole and a roof plane added to suit.

 

Just a point, because of the odd angle, the addition is narrower than the main house. That means the pitch will have to change to make the roofs line in. It would be much neater to make the new addition exactly the same width as the existing building.

Attached Thumbnails

• 

[Jay Preeshl]

Thanks Keith 

Appreciate it