1 reply to this topic

[Shay Bashaw]

Hi Everyone,

 

Can anyone tell form the images below why my wall top plates are not joining correctly?

It appears as tho the material is stopping at the centre line of the material, rather than mitring properly.  

 

Everything joins nicely in the plan view (2nd image) but not in 3D for some reason.

 

Any ideas?

Thanks in advance!

 

Attached Thumbnails

• 
• 

[Joseph Smith]

few things to check:

 

1.  check wall joins tolerance, work best at 6"

2.  check floor mode to make sure under the walls

3.  check wall heights, maybe not the same or one starting lower then the other.

 

sometimes i delete the wall then click UNDO then it'll join properly