5 replies to this topic

[Ron Sirolli]

I HAVE A EXISTING ROOF I AM PUTTING A ADDITION WHERE THE ROOF GOSE ABOVE THE EXISTING RIDGE SO FROM THE FRONT 

ELEVATION IT SHOULD HAVE A ROOF SHOWING BUT I CAN'T FIGURE HOW TO MAKE THAT WORK WHEN YOU TRACE THE NEW ROOF

IT MAKES A VALLEY THAT GO ABOVE THE EXISTING RIGE IS THERE A WAY TO EDIT THE TOP PART OF THE VALLEY I WOULD LIKE

A LITTLE INFO PLEASE 

THANKS RON

[Sam Morgan]

Use a bull nose roof edge on the roof you are trying to tie in to the existing roof then adjust until it planes with the old roof. 

[Ron Sirolli]

i try that Sam you mean edit the gable edge if i do that how do i get the gable back

[Sam Morgan]

 Bull Nose Roof Intersection.jpg   73.71KB   0 downloads  Bull Nose Roof Intersection 3D.jpg   111.87KB   0 downloads

[Ron Sirolli]

i got it Sam thank you i wish i knew how to add a drawing to this site

[Sam Morgan]

When you go to post a reply, over in the bottom/right corner is a box you can click that says "more reply options"....that's where you have to go to add an image.