3 replies to this topic

[Stephan Page]

Is there a way to add a 3" or 6" radius to Island/Peninsula Kitchen Countertops?  It seems that there must be, but I can't seem to figure it out...

 

Thank you

[Joseph Smith]

You'll have to draw a separate countertop then turn off the tops from the cabinetry.

 

DRAW/CABINET/COUNTERTOP

 

Once that's complete then you can add a curved fillet.  

[Stephan Page]

Thank you Joseph! 

 

I also found out from tech support:

 

Right click over the countertop and select "Explode Counter". This will separate the cabinet from the countertop, such that the countertop becomes it own object. You can the modify individual countertop to suit. In this case, use Tools > Curved Fillet to round the desired corners of the individual countertop object.

[Joseph Smith]

Thank you Joseph! 

 

I also found out from tech support:

 

Right click over the countertop and select "Explode Counter". This will separate the cabinet from the countertop, such that the countertop becomes it own object. You can the modify individual countertop to suit. In this case, use Tools > Curved Fillet to round the desired corners of the individual countertop object.

 

Too funny, I've never hovered over cabinetry and exploded countertop from cabinetry. (didn't know that existed)  Learned something today- THANK YOU!!