Jump to content


Photo

Adjust not snapping


  • Please log in to reply
3 replies to this topic

#1 Andrew Morrison

Andrew Morrison

    Member

  • Members
  • PipPip
  • 16 posts

Posted 10 February 2022 - 11:53 AM

I use cursor snap so for example when I adjust a wall to end at a perpendicular wall, it would snap to the wall if I was close/the red perpendicular snap would show. Now the red symbol appears but the wall ends slightly off the mark. Is this because of the recent update?

 

Thank you!



#2 Keith Almond

Keith Almond

    Advanced Member

  • Members
  • PipPipPip
  • 5,092 posts
  • LocationBrockville, Ontario, Canada

Posted 10 February 2022 - 11:59 AM

Check the wall join settings.


  • Andrew Morrison likes this
Keith

There are 10 types of people in this world ....... Those who understand binary, and those who don't.

Softplan user since version 5.5.2.5

www.homehardwarekingston.ca

#3 Andrew Morrison

Andrew Morrison

    Member

  • Members
  • PipPip
  • 16 posts

Posted 10 February 2022 - 12:14 PM

So turning on the tolerances helps, but do I have to do that for every new wall?



#4 Andrew Morrison

Andrew Morrison

    Member

  • Members
  • PipPip
  • 16 posts

Posted 10 February 2022 - 01:47 PM

Ah I figured it out, the snapping started working again when I went into System Options, Wall Trace Line, and changed both to "Center."

 

Thank you!






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users