I'm creating a region to nest to, seems after I name it, the lines want to pop over to the edge of the wall?
It works if i make it much bigger, but now it doesn't include the front wall.
I'll figure this out
Posted 19 March 2022 - 09:59 AM
Since the wall is a single entity, i wouldn't expect it to be semi-included. I would expect as you have it. that it's either ALL included or ALL excluded. The same way that block select works.
Posted 19 March 2022 - 11:27 AM
Sorta doesn't make sense, that if you are nesting an area of a drawing, that it wouldn't include everything in the nesting area, but seems that I read during the
last upgrade, that the nesting is setup a little for a future use??
I ended up just putting it to a planset page and croping it to how i need it.
Just to add, the only time i get mad at Softplan is when i decide to turn off corner boards, Quions and such, and I just never can remember where it moved to. was originally in system trim.
Posted 19 March 2022 - 02:41 PM
I would expect you to be nesting full drawings for use in future project. Not nesting portions of drawings. But maybe that's just me.
0 members, 0 guests, 0 anonymous users