5 replies to this topic

[Stacey Raymond]

HI Everyone,

I'm new-ish to SoftPLan, and I'm wondering if it possible to edit my winders so they converge onto a centre point? Right now they have about 6" of tread on the inner aspect, which would be lovely, but I'm working within tight space confines, so I need them to be as tight as possible.

Thanks!

Stacey

[Henry Buckner]

This is adjusted using the radius setting for the landing. It's with the other dimensions when you edit the angled section of the stair.

[Stacey Raymond]

This is adjusted using the radius setting for the landing. It's with the other dimensions when you edit the angled section of the stair.

 

It worked! Thank you!

[Richard Rubinski]

If you look at the bottom of the angled tread tab it will show the minimum tread width as you adjust your radius.

[Gary Wicklund]

I’m sure you’ve checked your local building code, but you may need a min run at the center of your radius?

[Stacey Raymond]

I’m sure you’ve checked your local building code, but you may need a min run at the center of your radius?

Yes, our code allows winders to meet at a point, so no tread depth at the centre.