Have you tried putting an area schedule on a new drawing and then add that new drawing to your plan set template?
I can place the area schedule on my cover sheet successfully, but I have a custom table that I want to use and I was hoping that I can some how have SoftPlan grab the SF figures and plop them in fields of my custom table.
I did reach out to the folks aat SoftPlan and this was their response.
The Information Stamps (ie: @area1) would need to be placed directly on the drawing that contains the Area polygons in order to display a square footage. I'd suggest adding an Area Schedule directly to the Plan Set page (Notes>Area Schedule) or typing in the values manually.
Too bad there's not a workaround to just get the actual numbers and not the default schedule that comes with it.