Jump to content


Photo

Wall Lines

Walls Lines Definition 2x6

  • Please log in to reply
6 replies to this topic

#1 Wendall Hilty

Wendall Hilty

    Advanced Member

  • Members
  • PipPipPip
  • 136 posts

Posted 31 January 2023 - 01:45 PM

Does anyone know why this exterior wall is showing lines at the corners and where the interior walls come in?

 

Attached File  Walls.png   5.23KB   2 downloads


  • Jeremy Plum likes this

#2 Matthew Dunson

Matthew Dunson

    Advanced Member

  • Members
  • PipPipPip
  • 163 posts

Posted 31 January 2023 - 02:02 PM

Maybe check your joint tolerance for each wall? Usually, they do that if the tolerances are less than the 6" default, but I have experienced that problem for corners even when the joint tolerance is not altered a few times. Try using the adjust tool to move the wall slightly over the corner to see if it will disappear. For the other intersections, I am unfamiliar with what you are experiencing.



#3 Chris Proost

Chris Proost

    Advanced Member

  • Members
  • PipPipPip
  • 139 posts
  • LocationRichmond, VA

Posted 31 January 2023 - 03:07 PM

Are all of the walls the same height and offset?



#4 Wendall Hilty

Wendall Hilty

    Advanced Member

  • Members
  • PipPipPip
  • 136 posts

Posted 31 January 2023 - 03:15 PM

The wall tolerances are still at 6". No amount of moving or adjusting removes it. The walls are all the same height and offset.



#5 Keith Almond

Keith Almond

    Advanced Member

  • Members
  • PipPipPip
  • 5,092 posts
  • LocationBrockville, Ontario, Canada

Posted 31 January 2023 - 04:03 PM

I have this quite regularly with my basement walls. If it's the same issue, filleting them together corrects it.


Keith

There are 10 types of people in this world ....... Those who understand binary, and those who don't.

Softplan user since version 5.5.2.5

www.homehardwarekingston.ca

#6 Wendall Hilty

Wendall Hilty

    Advanced Member

  • Members
  • PipPipPip
  • 136 posts

Posted 31 January 2023 - 04:08 PM

Thank you. I tried it but that wasn't successful either.



#7 Tim Stockton

Tim Stockton

    Advanced Member

  • Members
  • PipPipPip
  • 312 posts
  • LocationWichita, KS

Posted 06 February 2023 - 10:17 AM

If your walls are the same height and the offset is also the same (both must be true), then try a cleanup first, if that doesn't work, simply adjust the walls slightly to where they meet in the middle.  If that still doesn't work, then adjust the join tolerances to 2" and cleanup and readjust if needed.







Also tagged with one or more of these keywords: Walls, Lines, Definition, 2x6

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users