2 replies to this topic

[Tomi Perl]

How can you create a standard tray ceiling, coffered ceiling, or coffered with tray?  If you use the bulkhead you are set below the top of the wall. Is there a way to offset a bulkhead and or ceiling and bulkhead together to have it sit on top of the wall as it would? Thanks in advance

[Yvon Gonthier]

If you edit your bulkhead, you can set the offset to zero, which means that it will be lined up with the top of your wall. You than need to edit your ceiling to edit the offset (un-check clean-up)

[Tomi Perl]

thank you