4 replies to this topic

[Dave Pazyniak]

Good Morning,

 

I do not have a lot of experience in wall style creation, but I thought this was simple enough for me to handle, but...

 

I have an 8" block wall building.  I want the front wall to be 4" block and 4" brick.  My footer and block wall join correctly, but the brick does not run to the end of the wall (see attached).  Is something wrong in my wall def.?  I do not need this to render correctly, but the corners look wrong in the rendered view also.

 

Thanks,

Dave

Attached Files

•  Screenshot (54).png   42.71KB   4 downloads

[Keith Almond]

It's nothing to do with the definition...

 

Use TOOLS > ADJUST WALL MATERIAL > BUTT to correct it.

[Yvon Gonthier]

Try using in the Tools>Adjust Wall Material>Butt End. Sometime, you also have to switch to framing mode to have the wall with the finsih that you want to extend in front of the other wall (as per attached) but since you don't have framing, might not be applicable.

Attached Files

•  Framing.JPG   91.39KB   3 downloads

[Dave Pazyniak]

Thanks, guys!  never used that one before...

[Mark Petri]

Use the "adjust wall material" (wall join) tool and have the brick butt to the outer edge of the block wall.