Hello,
I don't know if anyone is still using SP2012 anymore. I have some corner trims that extend beyond the top of the roof. Does anyone know what causes this?
Thanks
Wes
Posted 12 August 2021 - 07:59 AM
Try running clean up. Try adjusting the wall height on the gable wall if it is set to fit to roof. I can't remember if you can override the height on corner trim in 2012, but try that if possible. Or, when all else fails, uncheck corner trim after tracing the outline with a solid polygon that you can adjust the offset and height of. Then use that as your corner trim.
Mark Petri
Petri Building and Design
Posted 12 August 2021 - 08:40 AM
Gary,
Yes it is taller than the wall, but in 2012 we do not seem to have control of the cornerboard height.
No, deleting the banding makes no difference.
Mark,
Clean up run, no difference. Adjusted wall heights, no difference. Remove gable provided by roof, no difference. Made roof edge hip instead of gable, no difference. I will have to go the solid route.
Thanks all,
Wes
Posted 12 August 2021 - 11:05 AM
May I suggest you upgrade your software?
SoftPlan →
General Questions →
Raise Roof - Window Pediment Clearance, Heel Height, Knee WallStarted by Steve Gray , 08 Feb 2024 Roof, Knee Wall, Raise Roof and 1 more... |
|
|
||
SoftPlan →
SoftPlan 2024 →
Roof SettingsStarted by Mark Petri , 11 Dec 2023 Roof, Settings, Project Settings and 2 more... |
|
|
||
SoftPlan →
SoftPlan 2022 →
Drawing Roof PlanStarted by Bruce Schlittler , 10 Sep 2023 Visibilities, Roof |
|
|
||
SoftPlan →
General Questions →
Bird box lining up with corner trimStarted by Kylene Baney , 08 May 2023 bird box, corner trim |
|
|
||
SoftPlan →
General Questions →
How to Model Roof CablesStarted by Verlin Klassen , 15 Mar 2023 Cable, cables., roof cable and 2 more... |
|
|
0 members, 0 guests, 0 anonymous users